XRAY - Model racing cars

Hi evereyone im new to the touring car sceen and need some help with my m18 pro , i have the mamba brushless setup with a c4 9200 motor,42/13 gears,2cell lipo 7.4 21oomah battery and the car flys and is very fun to drive ,i race indoors on a rcp track i think thats the name but i could be wrong its like rubberish foam track like i said im new to this so i could be wrong . Its a road course and the problem that i am haveing is that the car pushs really hard in the corners i have tried diffrent setups with the flex frame and that did make alittle diffrence but not as much as i would like. for that track size it is about 70 feet long on the front section the corners are like four to five cars wide i have the throttle set to the lowest setting ,i know that i could use a better controller i have a pretty cheap one but it works just dont have all the programing that like a m8 does and i dont have have the extra money right this sec to get one so i am trying to do my best with what i have like i said the track is a road course that is 70 feet on the front and the corners are three to four cars wide any help would be great thanks

To help others assist you, please include a descriptive title for your posts.

Also as a courtesy please do not type in all caps as it makes your posts harder to read and is considered 'shouting' in common forum etiquette.

Now that the formalities are out of the way...welcome to the board!

Perhaps you can post your current setup and some information regarding the size and type of track that you run on so that people can help provide you with some specific assistance

As Chris suggests, let us know your setup. Fill one out and link us to it so we can go over it. If you feel this is too much, then let us know the surface, size, of the track. On the car the motor, batts, and what is changed from the manuals setup.

One quick question is have you tried loosening your multiflex side screws on the front of the car to see how it responds?

Might want to try a softer tire to get more grip on the front end.

A.W

More info on your set-up. Info useing a set-up sheet. Info of, Tires used( rubber or foam), shore of foam used, Toe-in/out on front & rear suspension, motor used & gear ratio, size of track & composition of track(dirt or asphalt).
Better to get info, then just shotgunning your problem with.