XRAY - Model racing cars

Hi, i build up my new new M18T and i loved it

But i have a single problem with the steering linkage. The lower screws reach the plastic cup of the diff output. Which makes the steering "a bit" inacurate
I think the ballbearings in the steering arm have to much clearance themselves!?

take a look:






Can you help me? Is there a workaround?

thanks

You can raise the upperdeck by placing some washers under it at the screws.

I suggest you will tighten the M3x10 screw that holds the bearings in steering arm together with the top deck.

You might also check to see if your using the 2.2X8 screw versus a 2.5 which would have a bigger head.