| XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
| aluminum steering plate and aluminum rear hub hole positions https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=101&t=19601 |
Page 1 of 1 |
| Author: | lijiayang1988 [ Wed Sep 27, 2017 04:00:01 ] |
| Post subject: | aluminum steering plate and aluminum rear hub hole positions |
Hi, Martin Just a quick question: Can you please tell me compared to the stock composite parts, how can I match all the hole positions on the aluminum steering plate and rear hubs? Especially for the aluminum rear hub, for example if I am running the middle hole on the stock composite rear hub, which hole should I use on the aluminum hub to match the same geometry? How thick the shims I should use? Thanks a lot. |
|
| Author: | Martin Bayer [ Thu Sep 28, 2017 07:08:48 ] |
| Post subject: | Re: aluminum steering plate and aluminum rear hub hole posit |
Hello To have similar feeling position like composite steering ackerman you need you use inside back hole with 5mm shims under. Alu rear hub i suggest front out side position. But if you want to go close to what you have on composite go to rear position on middle with 5mm shims. |
|
| Page 1 of 1 | All times are UTC + 2 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|