XRAY - Model racing cars

Greetings,

Following the base kit manual, i use the 2mm conical washers on both the c-hubs and the steering plate.
This generates an angle from the plate to the hub that is not in line with the A-arm. Making the worst bumpsteer
I have ever seen.....Is this how its supposed to be? My Kokomo and K2 are nothing like this in terms of geometry.

Am i doing something wrong? Can anyone send me a picture of how there XB4-16 looks?
I'm going out of my mind, I can fix it by adding 4mm under the servo posts, removing all the conicals and shimming the top plate
by another 1MM to get close to what I think is normal.

Any help would be awesome

So i flipped the steering bar upside down and removed all shims and its nearly perfect now.
Had to trim the body back a bit because it was rubbing but, the setup is dialed. Still seems not
right.

But all cars work very good! When i check my akerman link i don´t see something wrong.

Send picture here.