XRAY - Model racing cars

Hey All,

New to the Xray platform as I will be receiving an new XB4 in the next few days.

Looking through the manual and setup sheets ahead of time I notice that there aren't any shock shaft measurements or free length measurements to get baseline droop setup, aside from the number of shims under the piston.

How are you all doing it? Are you just setting shock shaft length to one consistent measurement or are you using some form of droop measurement during final setup?

Thanks a bunch.

- Jake

Hello

I hope you will enjoy XB4

In manual you can find basic setting. Witch is using shim under piston and when you screw ball joint on shock shaft basic set-up is 1-1,5 mm to end of tread on shaft.
Or you can see my set-up sheet from races where is also measure of distance shaft between shock body and ball joint.