| XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
| rear bulkhead spacer https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=101&t=18562 |
Page 1 of 1 |
| Author: | zixxer [ Wed Feb 12, 2014 18:15:03 ] |
| Post subject: | rear bulkhead spacer |
hello everyone on the rear bulkhead black spacer that goes between the chassis and the bulkhead ....do i have to have an optional piece in order to not run the spacer thus lowering the bulkhead ....i was a touch confused on the addendum to the instructions .......xb4/14 spec |
|
| Author: | auto2 [ Mon Feb 17, 2014 03:17:48 ] |
| Post subject: | Re: rear bulkhead spacer |
yes you need new hinge pin holders or you can sand down yours to sit flat on the chassis |
|
| Page 1 of 1 | All times are UTC + 2 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|