Hello,
sorry for mixing up the shims
The 4,8mm shim is the one included in the setup system and is intended for similiar cases as for the XB4 shim - axle stubs that don't allow an aligned mount of the stands.
Greetings
| XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
| XRAY XB4 Part # 108927 https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=101&t=13556 |
Page 1 of 1 |
| Author: | favoajc [ Mon Jun 10, 2013 00:16:20 ] |
| Post subject: | XRAY XB4 Part # 108927 |
Could some one please post a photo or a link to where these are used please ? The #108928 go on the rear axles as spacer for when you use the set up station. Thank you so much for your help......... |
|
| Author: | JoMei [ Mon Jun 10, 2013 18:09:36 ] |
| Post subject: | Re: XRAY XB4 Part # 108927 |
Hello, see: http://www.hudy.net/xhudy/news/newsdesc ... egoria=191 (click on the upper picture) These spacer are put on the rear axle before the rear stands from the setup system. The non-threaded part of the rear axles is a little bit thicker then the threaded part, so the stands can't be put up to the wheel hub - therefore the mounting without the spacer is non satisfying. With the spacer the stand has flat surface to lean up again and can be mounted in an angular angle toward the axle. Greetings |
|
| Author: | favoajc [ Tue Jun 11, 2013 16:11:48 ] |
| Post subject: | Re: XRAY XB4 Part # 108927 |
Thanks for your reply JoMei.... The 108928 Will do that as you say But the 108927 there to small as inside diameter. These are the ones am talking about........ https://www.rc-mushroom.com/advanced_se ... &x=39&y=15 |
|
| Author: | brano [ Wed Jun 12, 2013 06:57:08 ] |
| Post subject: | Re: XRAY XB4 Part # 108927 |
The #108927 spacers had internal hole of 4.8mm however the XB4 has 5mm drive drive axles so the #108928 spacers were offered, now these will replace the #108927 spacers as also the next set-ups #108905 will be with 5mm holes. |
|
| Author: | JoMei [ Wed Jun 12, 2013 12:03:42 ] |
| Post subject: | Re: XRAY XB4 Part # 108927 |
Hello, sorry for mixing up the shims The 4,8mm shim is the one included in the setup system and is intended for similiar cases as for the XB4 shim - axle stubs that don't allow an aligned mount of the stands. Greetings |
|
| Author: | favoajc [ Wed Jun 12, 2013 14:48:07 ] |
| Post subject: | Re: XRAY XB4 Part # 108927 |
Thank's guys for your help..... Love the XB4 great car and big Brother XB9 is awesome to drive as well.......... 
|
|
| Page 1 of 1 | All times are UTC + 2 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|