hi there,
new here, just got my XB4 over the weekend and have completed building up the kit.
build process is easy and all parts fitted without any problem.
however, when all parts are connected, batt charged, wanted to run the kit and i started having problems with turning right.
problem i faced is 3x10mm ball hex steering servo side is actually hitting the 3x12mm ball hex on the right front assembly side which in turn i could not have the full right steering.
on the left side, all is ok.
i have since taken out the 3x12mm ball hex and would like to ask will that be ok?..will it affect anything?
i have also tried using countersunk screws but to no avail.
can anyone advise?..i have tried to tighten all the screws all the way down but the 3x10mm hex still hits the 3x12mmball hex..
Please help..
| Attachments: |
|
File comment: Left Side all in good order..full steering steering 3.JPG [ 120.35 KiB | Viewed 3494 times ] |
|
File comment: No full steering when turning right steering 2.JPG [ 108.63 KiB | Viewed 3494 times ] |
|
File comment: Right Side hitting the 3x12 hex steering.JPG [ 104.23 KiB | Viewed 3494 times ] |
