| XRAY - Model racing cars https://setup.teamxray.com/xsetup/legacy/ |
|
| Front and rear Eccentrics https://setup.teamxray.com/xsetup/legacy/viewtopic.php?f=101&t=13453 |
Page 1 of 1 |
| Author: | Afrop [ Wed Mar 27, 2013 20:42:12 ] |
| Post subject: | Front and rear Eccentrics |
is there anybody out there that could provide a very helpful idiots guide to the Eccentrics setups? Struggling to get my head round the adjustments and how they work. Dont understand how you adjust the different items but with the same bushings(I know i'm a thicky  )thanks |
|
| Author: | Z00M [ Thu Mar 28, 2013 03:56:40 ] |
| Post subject: | Re: Front and rear Eccentrics |
In your kit you received more than 1 type of hinge pin bushing. There were: Middle dots Centre offset dots Corner offset dots The car is built in kit form with the middle dots. The setup sheet show 9 possible positions for each hinge pin holder. Obviously the centre dots give you the middle position (1 position) With the centre offset dots you can orient the dot up, down, left or right (4 positions). With the corner offset dots you can orient them bottom right, bottom left, top right, top left (another 4 positions). Hope this helps. If not, get the 3 types of bushes in front of you (yes I know there are .5mm and 1mm offsets but trying to simplify for this explanation), and try and line them up in the orientation of the user manual until it makes sense. |
|
| Page 1 of 1 | All times are UTC + 2 hours |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|